WTS Tikka Safe Clean Out- LEFT HAND Action/Stock, Barrel, Parts

[Yodie]

Time to clean out some stuff to make room for new project I’m planning:

OEM Tikka firing pin assembly, still factory sealed. $110 shipped.

Adding:
100pcs, 2x fired, Alpha Munitions Brass, in hinge top case. Cleaned, annealed, sized, 50 are primed with rem 7 1/2 other un primed. $85 shipped

PayPal Only, f/f greatly preferred.

 

[Brian421]

I will take the action. Sending pm


Sent from my iPhone using Tapatalk

 

[The Angelo Kid]

I'll take the level. Sending PM.

 

[The Angelo Kid]

I'll take the rings too if they are still available. Added that to my PM.

 

[Yodie]

Action, rings, bubble level sold, initial post edited to reflect.

 

[lowade1111]

How is the fit on the stocky's? Did you do any inlet or bed work on it? I have one at the smith right now because it wasn't a drop in fit like advertised but tempted on this one too. They are good quality stocks.

 

[Yodie]

I didn’t have any issues, never felt it needed bedded or anything tight when installing.

Action screws torqued to 35 in. Lbs I was able to get easy 10 shot groups under 1" and 20 shot groups under 1.25" when all these parts were assembled.

 

[K_pem]

how much did the action go for ?

 

[lowade1111]

I didn’t have any issues, never felt it needed bedded or anything tight when installing.

Action screws torqued to 35 in. Lbs I was able to get easy 10 shot groups under 1" and 20 shot groups under 1.25" when all these parts were assembled.

Right on. Seems hit or miss on these stocks with how they fit. Not a big deal at all and easy enough to fit if needed.
Do you know the part number for the 1" limbsaver pad you used?

 

[Yodie]

I can’t find any info on it, I believe it’s the one Stockys sells as an accessory in their website, it’s not a direct fit, but where it doesn’t fit it’s oversized a smidge and no part of it is undersized, I’ve just never taken the time to fit it because it’s very close and hardly noticeable.

 

[lowade1111]

I can’t find any info on it, I believe it’s the one Stockys sells as an accessory in their website, it’s not a direct fit, but where it doesn’t fit it’s oversized a smidge and no part of it is undersized, I’ve just never taken the time to fit it because it’s very close and hardly noticeable.

Thanks for the info. I wasn't sure if those would fit the tikka version. I'll check them out and I'll get back to you on the stock. Torn between buying this or another peak44 stock.

 

[Yodie]

Added die and brass

 

[lowade1111]

I can’t find any info on it, I believe it’s the one Stockys sells as an accessory in their website, it’s not a direct fit, but where it doesn’t fit it’s oversized a smidge and no part of it is undersized, I’ve just never taken the time to fit it because it’s very close and hardly noticeable.

PM sent