Sold Tikka 6cm prefit, brass, dies

[cubdriver84d]

Preferred 6mm creedmoor shouldered tikka prefit. 156 rounds on it. See pic for specs. 99 pieces of 1-2x fired Alpha LRP brass. Hornady seating die, custom honed Forster FL die, and hornady lock-n-load modified case. $spf tyd for everything. Not willing to split it up at the moment, unless the brass and dies go first.

 

[UngulateGuardian797]

PM sent

 

[lak2004]

What bullet did you shoot with it? Weight on barrel?

 

[cubdriver84d]

What bullet did you shoot with it? Weight on barrel?

I shot a box of factory eldm which grouped great. The rest were 95gr DRT terminal shock which I could barely get below 2 moa. I think the 7 twist is just a little fast for them. Killed a couple elk though.

I didn’t weigh the barrel before I installed and haven’t taken it off yet. I was going to leave it on until it sells but if that’s the deciding factor for some I can remove and weigh it.

 

[Tanner]

Curious on the weight of it while installed on the action.

 

[schweinstein]

Is the FL die a bushing style die or standard?

 

[cubdriver84d]

Is the FL die a bushing style die or standard?

Standard but custom honed by forster.

@Tanner 7.8lbs as it sits with an ultra 7.

 

[Tanner]

Standard but custom honed by forster.

@Tanner 7.8lbs as it sits with an ultra 7.

Thanks! Nice setup. Interested

 

[cubdriver84d]

Still available.

 

[The Guide]

Still available.

What speeds were you seeing with what bullets? What kind of accuracy were you seeing?

Jay

 

[cubdriver84d]

What speeds were you seeing with what bullets? What kind of accuracy were you seeing?

Jay

About 2750 and 1.25” 10 round groups at 100 yd with factory eldm. About 2” and 2950 with the drt.