T3x vs CTR Bottom Metal Compatibility Question

[regulator795]

I am selling a Manners PRS1TK stock and a potential buyer asked if it could accept CTR magazines. Currently I run a T3X with factory bottom metal on the stock. Is it possible for the CTR Bottom Metal to be put on that stock and to use a CTR rifle without any additional inletting? The stock was glass bedded for my T3x.

 

[Antares]

No. You can put "standard" bottom metal in a CTR inlet but not the other way around. The CTR bottom metal is wider that the standard bottom metal.

 

[regulator795]

No. You can put "standard" bottom metal in a CTR inlet but not the other way around. The CTR bottom metal is wider that the standard bottom metal.

Thanks!

 

[Macintosh]

No as-is. But the inlet could be modified to fit a ctr inlet. The opening for the bottom metal is the same length and same inside, but the ctr is slightly wider so the bottom opening would need to be opened up a bit. If someone was handy enough to do this themselves it might be worthwhile, otherwise probably better for him to wait for a stock with a ctr inlet.