Stockys stock mod

[Bcoonce117]

Has anyone drilled and added a spartan precision gunsmith adapter to a stockys stock? I want to install one near the center of the stock in front of action screw. Just don’t want to mess up the carbon. Obviously I would epoxy in place but I don’t want to compromise strength of stock.

 

[passinggas33]

I did 4 of them. Not hard. Buy the bit recommended by Spartan. Put tape down to help splintering (not sure if necessary but I did it anyway). Small pilot hole, then get to drilling. Check depth frequently. Finish off and epoxy. The end. Took me about 15 minutes per stock once I had it all set up.

 

[Bcoonce117]

Perfect. I’ll probably do that then. I feel like it’ll be perfect for shooting for tripod like that. More stable