SRS all new Ti HUB to CB / banish

[Salmon River Solutions]

We just shipped a bunch of these HUB adapters off to Arizona for DLC coating and will have them back in about 2-3 weeks.

These are made from 6AL4V Ti.

Special introductory pricing of 20% off.

1.1 oz makes this the lightest on the market.

HUB TO CB / BANISH-BRAVO – Salmon River Solutions

www.salmonriversolutions.com

 

[ChrisAU]

Need some ultralight HUB direct thread mounts, any plans for the future? Flush fit with some feature to allow removal, the ones with hex ends look weird on a carbon barrel.

 

[Salmon River Solutions]

Need some ultralight HUB direct thread mounts, any plans for the future? Flush fit with some feature to allow removal, the ones with hex ends look weird on a carbon barrel.

Have you seen our CB Brake? we have spanner wrench holes on the backside of it for easy removal... These same holes could be used on a Direct Thread HUB mount. So then its the same spanner wrench, the entire HUB adapter shrinks in thickness by at least 3/16" of an inch, and can be round instead of a hex. That section is where a lot of weight is also so this would be lighter.

In the works next week for prototyping.

Ken

 

[Soj51hopeful]

I thought this was going to be about the Shawn Ryan show.

 

[ChrisAU]

Have you seen our CB Brake? we have spanner wrench holes on the backside of it for easy removal... These same holes could be used on a Direct Thread HUB mount. So then its the same spanner wrench, the entire HUB adapter shrinks in thickness by at least 3/16" of an inch, and can be round instead of a hex. That section is where a lot of weight is also so this would be lighter.

In the works next week for prototyping.

Ken

Awesome!

 

[StupidLightweight]

Well done, SRS. I will be getting one. If it's like your other products, this will be a fine addition to my Banish Backcountry.