Sightron STAC 1-6x24mm SFP Field Eval

Status
Not open for further replies.

Formidilosus

Super Moderator
Shoot2HuntU
Joined
Oct 22, 2014
Messages
9,981
This is a field evaluation of the Sightron STAC 1-6x24mm SFP scope. This scope was sent to Ryan from Sightron for the Evaluation. The baseline 20 round group with this lot of ammunition was 1.3” at 100 yards.



The scope and weight-
IMG_7071.jpeg


IMG_7073.jpeg


Turrets:


.25 MOA elevation and windage turrets are capped, resettable, and revolution indicated.
IMG_7075.jpeg




IRAR1 SFP reticle:

IMG_7079.jpeg



Illuminated-
IMG_7085.jpeg


The reticle is a BDC, half donut type.



Cont….
 
Last edited:
OP
Formidilosus

Formidilosus

Super Moderator
Shoot2HuntU
Joined
Oct 22, 2014
Messages
9,981
Zeroing:

Scope was mounted as standard with NF UL rings. The rings were degreased and installed with 65 in-lbs on base screws, and 18 in-lbs on ring cap screws. The baseline 20 round group with this lot of ammunition was 1.3 MOA at 100 yards.


Zeroing went without issue. Boresight, fired one round, adjusted, fired three, adjusted, fired the reminding 6 in the dot. The center of the 6 round was high .25 MOA and right .25 MOA. I did not adjust it out.

IMG_7666.jpeg




Drop Evaluation RTZ and “Tracking”:


For an explanation see- Scope Field Eval Explanation and Standards


The “test” consists of three 18” drops on a mat- one left/right/top with a shot to check zero after each drop. Then the exact same thing repeated from 36”. Then three drops on all three sides for nine drops on the last part- 15 drops total. This is not “abuse”. The 18” drops are a joke really. The 36” start showing something. And when a scope make/model consistently goes through the whole thing without losing zero, and makes it through the high round count portion, failures in actual use are almost unheard of.

This one was conducted on semi packed soil.

IMG_7667.jpeg

It shifted up.5 up, and right .5 MOA.

Torqued ring cap screws to 25in-lbs, adjusted down .75 and left .5 MOA-
IMG_7668.jpeg




2nd Drop eval- no issues

IMG_7669.jpeg




RTZ: no issues

IMG_7670.jpeg



Adjustment: “tracking”.


24.75 MOA between dots. It actually moved 23 MOA for a 7% error.
IMG_7671.jpeg




Conclusion:

Once again 18 in-lbs lets a scope move enough to cause a slight zero shift. 25in-lbs corrected it. Other than the 7% adjustment error at 24.75 MOA, the scope worked without issue.
 
Status
Not open for further replies.
Top