Scope Bumper Scope caps

[Ajsomp]

I could be wrong - but I’m fairly certain these are the scope caps @Formidilosus has on a few rifles

THE Scope Bumper™

The Original Scope Bumper

scopebumper.com

In a pre-order status currently.

I have no affiliation I’m just a guy who has not found the “Goldilocks” scope caps yet.

 

[Weldor]

There was a member going to make some , unfortunately never heard back from him. Look 3d printed caps, prices are all over the place.

 

[nm.otter]

Looks like a great design -- and $pendy!

 

[WyldGoose]

Look good. Hope we get a RS code…

 

[Formidilosus]

Those are the ones that I have been using-



They work and are the least annoying caps currently out there.

 

[Ajsomp]

Those are the ones that I have been using-
View attachment 957330


They work and are the least annoying caps currently out there.

That’s what I thought. I ordered a set and hopefully they arrive before I leave for Colorado.

Side note - do you prefer the leather or neoprene cheek piece on the rokstok? Been debating on throwing one on

 

[Formidilosus]

That’s what I thought. I ordered a set and hopefully they arrive before I leave for Colorado.

Side note - do you prefer the leather or neoprene cheek piece on the rokstok? Been debating on throwing one on

I prefer the leather, but the neoprene is thicker.

 

[rharbaugh]

Do the SWFA 10x and 6x use the same size?

 

[Ajsomp]

Do the SWFA 10x and 6x use the same size?
View attachment 957333

From my measurements, yes. I got the same measurements on my 6x as what’s listed for the 10x. So long as you are talking the rear focus 10x. Can’t speak to the side focus version.

 

[nm.otter]

I asked about that yesterday. Will be sending measurements this morning to see what they say.

 

[MontyMontana]

These look a lot like the PVS covers for NOD's, great idea!

 

[Ajsomp]

These look a lot like the PVS covers for NOD's, great idea!

I believe they make those as well

 

[nm.otter]

The ocular on my 6x42 Gen2 measures a hair over 39.5mm OD -- a fair bit smaller than their tool recommends for the (presumably Gen1) 10x42.