RokStok

[TheCougar]

Yes, mine was spot glued and screwed. I worked a razor blade deeper and deeper going around and in between the stock and buttpad. Eventually it’ll pop off. They used a nickel to quarter sized dab of epoxy at each screw and ran the screws in. I’m putting my own spacer setup in it. Haven’t done it yet though. It’ll use recessed nutserts in the first 1/4 spacer which will be permanently glued to the stock. Additional spacers and buttpad will get screwed on with machine screws.

I did the same thing to get it pried off. Eventually I got it off without damage.

 

[TaylorSnipesOutside]

Tikka says the action footprint is the same, I don't know if there's anything specific to the rokstock that would cause it not to fit but on the surface it should work.

Per UM, the answer is no

 

[atmat]

Per UM, the answer is no

@Unknown Munitions — why is that? I thought T1x stocks could be used on T3x actions without modification, while the opposite isn’t true unless you modify the cutout for the bolt release?