Ring height

Joined
Nov 27, 2023
Messages
528
Anyone happen to know what height rings I need to mount an NX8 4-32 on a Tikka T3X tac a1?

To clarify, Mountain Tech highs are close, but too low. I’d like to keep it as close to the bore as I can, so I don’t want to just order something super high. Assuming this is a combination some will have experience with.

Open to NF, Warne, maybe others.
 
It’s a Tac A1 (factory Tikka chassis rifle). Much different than a regular T3X with a rail on it.

I’ve been looking into it since I posted and lots of people are using “extra high” or a one piece ring setup.
 
Why worry about getting it as close to the bore/rail as possible? I just get the 1.5"ish high rings for that type of rifle even if it doesn't have a full picatinny fore end. If i'm not mistaken, that 1.45-1.5" height is typical "AR height" for rifles with full length pic rails like yours.

If you must cut it close, NF has options a little higher than those warnes before getting to the 1.4x+ height.
 
Back
Top