Reloading for Long Range Hunting: Part 1

[Sam Millard]

[video=youtube;8UAD1xnEhfI]https://www.youtube.com/watch?v=8UAD1xnEhfI[/video]

 

[Craig Van Arsdale]

This is great Sam! Thanks. I'm just getting into reloading so I'll be staying tuned.

 

[bhylton]

Good stuff. Any concern about getting the case lube down into the case? I have never used a spray lube before. But i know what the standard RCBS case lube does when it comes in contact with powder

 

[Sam Millard]

Good stuff. Any concern about getting the case lube down into the case? I have never used a spray lube before. But i know what the standard RCBS case lube does when it comes in contact with powder

No. I've been using it since 2003. I don't know exactly how many cases I've sized in that time span, but 15,000 wouldn't be far off

Never had any problem.

 

[WestDan]

great stuff. certainly didn't think about running cases back through the tumbler after some of those steps but im going to try it out for sure.

 

[jwb300]

Great Video Sam - I'm looking forward to part two.

Cheers,
JWB300

 

[HOT ROD]

Thanks a lot Sam. Cant wait for part 2..

 

[AZ Vince]

Great video.
I've not cleaned the carbon out of the case neck but I'm going to give it a go and see how I fare.

 

[Retterath]

Great info. That was going to be my next question I was going to post was step by step how u guys reload. Thanks again

 

[Shrek]

Sam , have you tried SS wet tumbling ? I have spotless necks and primer pockets without bushing , reaming , or steel wool buffing. If you like clean brass I highly recommend SS tumbling.

 

[Sam Millard]

Sam , have you tried SS wet tumbling ? I have spotless necks and primer pockets without bushing , reaming , or steel wool buffing. If you like clean brass I highly recommend SS tumbling.

While I don't doubt they work well, I'm going to stick with what I have. I don't care what the inside of the case looks like, I just want the outside clean.

 

[fire arrow]

Sam did you swap out the cutter on the Sinclair trimmer for the carbide one, or is it the stock one? Was wondering if the cost is worth the up grade.

 

[Sam Millard]

Sam did you swap out the cutter on the Sinclair trimmer for the carbide one, or is it the stock one? Was wondering if the cost is worth the up grade.

That's the regular one. Cuts very nicely, no chatter.