Rekluse Clutch and how to ride one

[Jesse Jaymes]

Wanted to start a separate thread. Just bought a Husky FE 350. It has a Rekluse clutch. I've never ridden such a modern bike. And I've never ridden a Rekluse. I am not sure I like it.


I stalled a zillion times. I would be rolling 5-10 mph and it would stall. I'd pull the clutch lever in and dump it, expecting it to POP back to life. No dice.

Could times with lever in coasting to a slow roll for a cut back, hair pin turn on a logging road....STALL.

Pulled in the clutch up hill to blip over a down log....STALL.

I quickly discovered you need to blip a little throttle on a decent in order for the clutch to engage for engine brake?

Any riding needs or tips for Rekluse clutch? Was a game changer on single track. Could ride slower than I cold walk. I can see how it's recommended to "ride up a gear". 1st was honestly too low.

Are these Love/Hate type additions?

 

[PAHunter777]

If you were having trouble with it stalling you probably need to adjust the free play. If there isn’t enough free play the clutch drags at low rpm and stalls.

 

[CRJR45]

Thats the whole point of the Rekluse is to not stall . I had one on my CRF450 and it worked fine , but you don't get engine brake with it at all . Come into the corner , mash the brakes , downshift and leave .

 

[Frozenlead]

If it’s stalling with the clutch in as mentioned above you may have issues with the clutch adjustment and it may be dragging.
I’d check your idle first, good chance it’s just too low.
As far as the bump starting, I don’t believe it’s possible without stopping and making a manual adjustment to essentially take the freeplay out of the clutch.

 

[Caseknife]

I don't ride bikes but was convinced to try a snowbike one time in the backcountry, it had a Rekluse. Worked awesome, start it in gear, give it gas and take off. No problem with braking with snowbikes and you are not going to bump start a snowbike either. Was going to suggest adjustment, pretty fine to get it right.