Red dot on Tikka? Advice needed.

Aimpoint made a T2 mount for while that screwed right onto the tikka rail, super low, ideal setup. And you can put any t2 footprint dot on there I'd think. I've had one gathering dust in a closet for a few years now.


Edited to add: I'd say this mount and a holsun 503 of some flavor would be a great combo. With a factory stock, I'd think you'll want something super low like this
i went with that mount for the micro orange i ve got for my 9.3x62. it will make a great back up even if i have open sights on it,
 
I went with a Trijicon MRO on two of my setups.
I’ve got an MRO HD weather additional magnifier on a 308, and a MRO 2MOA Green Picatinny Mount on a 270.
I find the MRO to be faster in use on a target that’s more than just feet away. I have no problems hitting my 12 inch gong at 300 yards with either rifle.
I find the green dot shows up better in hunting scenarios than red. The red MRO has a significant battery life advantage though.
 
Look up holosun 509t green and then the picatinny adapter for it. Mount it rear of action, gives bigger fov. ;)

I ran a 507c on a howa briefly and no prob moa 3 shot at 200 yards zeroing then punched a fist size 3 shot at 300 in middle of gong holding bottom of dot on top of gong. Gun no less accurate than before.

The 509 is enclosed, has solar primary and can run without a battery but battery there for when no light available. Shake awake etc.

I run their eps full size on a shotgun slug set up with shield cut out in receiver as lowest deck height plus all above features and big fov. But unsure you can get it to picatinny? So 509t the way I’d go.

Also run 507c on several .22’s, they are awesome little dots.
 
Back
Top