Reckoning Guide Lid Tab

[arnie]

Hey Everyone,

I tried searching the forums for this but wasn’t able to find anything.

Bought a guide lid to run on my reckoning (purchased May 2018) and my pack doesn’t seem to have the tab (outboard of the load lifter tabs) sewn on that is shown in the video.

I guess I could use the top load lifter tab, but the alignment is going to be off. Anyone else run into this?

 

[ChrisAU]

That is odd, someone may have cut them off prior? Mine definitely has them.

 

[deerhunter628]

Did you buy it used?

 

[arnie]

Nope, bought it directly from them. I’ll have to give them a call I guess.

 

[Mooseknuckle22]

Now that you mention it I don't think mine has them either. I bought mine new this year and have been attaching my guide lid to the load lifter tabs. Can anybody post a close up of the tabs in question?

 

[K9Kelly]

Here's a pic. Older bag with the holes in the frame sleeve has tabs for lid. Newer bag style uses the highest tab in line with the load lifter tabs. The 'new' design are slightly closer together, no issues either way. Hope this helps.

 

[arnie]

Yup, thanks! I ended up emailing them yesterday, and it was my fault.

 

[Mooseknuckle22]

Here's a pic. Older bag with the holes in the frame sleeve has tabs for lid. Newer bag style uses the highest tab in line with the load lifter tabs. The 'new' design are slightly closer together, no issues either way. Hope this helps.

Thanks for the pic. I guess i was using it correctly after all