I set my forstner trimmer to the "case trim length" and started trimming away. First 20 or so were fine and I got lazy on measuring. Trimmed another 20 or 30 when i realized they were looking a little short. Measured and it looks like my set screw backed out slowly, so I have cases from the min length of 2.160 all the way down to 2.120.
What should I do with the short cases; shoot them? toss them? Its good lapua brass, so I dont want to toss, but will if it will significantly impact my loads (Im guessing SD is most impacted first)
What should I do with the short cases; shoot them? toss them? Its good lapua brass, so I dont want to toss, but will if it will significantly impact my loads (Im guessing SD is most impacted first)
