One suppressor, two guns

[justin davis]

Thunderbeast

 

[juju]

First make up something similar in size and weight to one of the likely suppressors and tape it to the end of one of those barrels. Go take a hike. Your ideas may quickly change.

Also are these guns already threaded? Threading cost can seem a significant discount when applied to a new factory threaded rig.

 

[rhinorv]

First make up something similar in size and weight to one of the likely suppressors and tape it to the end of one of those barrels. Go take a hike. Your ideas may quickly change.

Also are these guns already threaded? Threading cost can seem a significant discount when applied to a new factory threaded rig.

Yes both are threaded and currently have brakes


Sent from my iPhone using Tapatalk

 

[JoeDirt]

Lot of good suppressor options that are not Thunderbeast prices. Buy a good Thunderbeast 30 cal can, then get a second cheaper can in 6.5 (or 7)

I save a few bucks and get cheaper direct thread cans and just leave them on my rifles. Only swap around cans on rifles that I dont shoot too often.

I dont like swapping cans around on my hunting/long range rifles, they're doped out with one can. I dont what to keep track of any point of aim issues if I use the rifle without a can.

 

[Ben.Hunting]

My buddies and I are all running Dead Air Nomad Ti XC suppressors on our 300 PRC's and 7 PRC's and are all very happy with them. I believe they are 6.74" long and 9.6 oz.