Neck bushings

[fisherman983]

Is there a noticeable difference between the rcbs and the short action customs?


Sent from my SM-S928U using Tapatalk

 

[thebulletman]

not sure about the rcbs but i was using redding and le wilson bushings before i got my nexus and converted to sac. never pin gauged bushings but my run out went from .0015 to .0006 average. using the sac mod sizer now.

 

[Len901]

go sac

 

[wapitibob]

Night and day

 

[Backcast88]

Not sure about RCBS bushing but I had great results with Wilson bushing in my Matchmaster dies. SAC is what my buddy uses and I tried them when i was waiting on my Wilson bushing. They performed very good. But the Wilson bushing were as good and 1/3 the price.

When I went to Forster I had to use their bushings and they have been phenomenal as well. No complaints. I like the Forster FL Bushing die better then my Matchmaster dies so I can only use their bushing but if I ran other dies, I would look at Wilson or SAC.

 

[Bater]

SAC cut my runout in a dozen cartridges in half compared to Redding and RCBS

 

[thebulletman]

SAC cut my runout in a dozen cartridges in half compared to Redding and RCBS

this, this right here. same experience for me.

 

[fisherman983]

Not sure about RCBS bushing but I had great results with Wilson bushing in my Matchmaster dies. SAC is what my buddy uses and I tried them when i was waiting on my Wilson bushing. They performed very good. But the Wilson bushing were as good and 1/3 the price.

When I went to Forster I had to use their bushings and they have been phenomenal as well. No complaints. I like the Forster FL Bushing die better then my Matchmaster dies so I can only use their bushing but if I ran other dies, I would look at Wilson or SAC.

With i had seen this reply before I ordered 2 sac bushings. Oh well, looks like overwhelmingly everyone sees better results with them

Sent from my SM-S928U using Tapatalk