Looking for RX-7 Ultra Spacers, HBX pro cam

[flyboy214]

Rokslide team,

I am looking for some bow tuning assistance. I picked up a used RX-7 ultra. It has the Grey shims installed but won't shoot a bullet hole unless the rest is near 1 inch from the riser.

I found a tune chart and it says to install the black spacers but I'm not sure which kit to get. The only one I can find is $60 and I'm pretty sure I only need 2 shims. (4 max) The cam says HBX pro.

If anyone has a link to the correct spacers or has a box of old ones left over I'd appreciate the assist.

 

[Sizthediz]

I'm assuming 3/16" axles? I will look when I get off work tonight.
What kinda tear are you getting

 

[flyboy214]

I found that exact chart. I'm a left handed archer, getting a tail left tear. With my rest set at 13/16". I had to move out all the way out to 1" to get a bullet hole and to me that is unacceptable.

Current shim configuration from the back of the bow is both thin Grey spacers on the left side of the bow.

I think the corrective action is to install the black shims to move the cam further left.

 

[Sizthediz]

What is ur center shot. I've found good luck around 3/4" on my rx8U. I will look tonight after work. If I have some i will pm you for your address

 

[vaeVictis]

I have the shim kit for this, DM me and I can mail ya some black ones.

 

[flyboy214]

I appreciate the help, a local contact was able to get me the shims. I'll try to install this weekend and report back.

 

[Sizthediz]

You got what you need?

 

[flyboy214]

After installing the black shims on the bottom cam the bow is shooting bullets with 2 different arrows and a bare shaft.

Great success

 

[Idaboy]

Following, looking for these shims

 

[Sizthediz]

Following, looking for these shims

What are you needing? What bow? What cams

 

[Idaboy]

What are you needing? What bow? What cams

Hbx Pro, Rx7 ultra

 

[Sizthediz]

Hbx Pro, Rx7 ultra

What color do you have in it?

 

[Idaboy]

Pm sent