LCA EZ Press dimensions

[Juice Newton]

Can somebody tell me what the I.D of the square tube is on their press where the draw board attachment would go.

 

[Rackfreak210]

I will measure mine when I get to the shop tomorrow. I know the standard press tubing outside dia. Is 1 3/4" but not sure on the I.d.

 

[Trees91]

DIY Draw Board for LCA EZ Green Press

It's no fine work of art, but it'll do. The pieces that slide inside the press frame are 1.5" square tubing...fits like a glove. I used 3/4" rebar for the bow holder sleeved with a scrap of fuel hose to protect the bow. The winch came from Amazon.

www.rokslide.com

This might help

 

[TheBootBowhunting]

1 9/16 ID, the L bracket on the draw board attachment is 1 1/2 with a layer of velcro on each side.