Kifaru Shapecharge frame sheet

[Singleshot]

I was wondering if anyone knew the correct way the frame sheet goes in on the kifaru Shapecharge? Does it go in with the exposed part of the stays to the inside of the pack and towards the bottom?


Sent from my iPhone using Tapatalk

 

[Bender]

Yep, that's correct Singleshot. I would check to make sure the profile of the stay is going the right way as the Shapecharge frame sheet is symmetrical and can be put in either way. Some of our assemblers might have it with the stay exit on top so it's easier to swap out stays if you want. The most comfortable way is to have the stay facing inside the pack. Sorry I didn't see this until now.

 

[Singleshot]

That’s good knowing that I had it in right, I was wondering because the stay wore a hole in my pack.


Sent from my iPhone using Tapatalk

 

[Bender]

Can you email me a pic of the damage to the pack and the part of the stay that wore through the fabric Singleshot? It shouldn't have done that if it was all put together correctly.