Yes, 5/16" field points work well. We also sell hardened steel field points on our website that match our Impact Collars.
No. That collar is designed to fit the arrow shaft. They use hit inserts that fit inside the shaft.Just want to make sure I understand. I current have Black Eagle Rampage arrows with their half outsert. I'm thinking about making the jump to Iron Will Broadheads. Will they work with that outsert?
Thanks
Bobrunner, our broadheads will work fine with that outsert. To use our Impact Collars on Rampage arrows, Billy Goat is correct. You would need to use both our Impact Collar and a HIT insert.
I'm only novice at building my own arrows but while the collar has pretty tight tolerances, it does slide on the shaft. Your field point or broad head will keep it on but most use glue or hot melt to attached it to the shaft. I heated up the collar and dabbed with hot melt.i know this is an old post but looking to do the same...is the "c" collar loose on the rampage 300? is that why you need to glue it on? also how do you get the glue in the collar...almost think you have to put the glue on the shaft but dont want to heat the carbon obviously
Like Bob said, Hot/Cold Melt. I heat up cold melt and wipe some around the tip of my arrow behind the cut, then heat the collar and slide it on and while it's still hot tighten a field tip snugly against it and then dip it in cold water. I don't put it in the collar first because if you do the collar doesn't sit flush against the arrow because hot melt gets in there, it's also a pain to get out of the end of your shaft. They stay on really well and when taking them off you don't need much heat to the collar for them to slide right off.i know this is an old post but looking to do the same...is the "c" collar loose on the rampage 300? is that why you need to glue it on? also how do you get the glue in the collar...almost think you have to put the glue on the shaft but dont want to heat the carbon obviously