Drop at comb, heel and face on Tikka T3X stock?

[plebe]

Anyone have good measurements on the drop at comb, drop at heel, and drop at face on a standard T3X stock?

I’ve seen some differing information on comb and heel drop on a few internet sites. I can figure drop at face mathematically but if you have it that’s great too.

Thanks.

 

[Macintosh]

So, this begs the question of what you measure from…bore centerline?

Heres what I just did.
Top of foreend pressed flat, held in place with a bag of shot.
Comb is exactly 5/8 to table top
Butt is 23/32 to table top (3/32 more than comb)
Face is half way between the two
I measured the standard stock NOT including the cheek riser.
Others may get a slightly different figure if they measure from a rod inside the bore, and depending on where on the rod they measure to.

 

[plebe]

Bore centerline is standard. But that’s helpful, thanks for going out of your way to measure.

Thought it would be something along the lines of common knowledge with restocking Tikka’s being very popular conversation on the forum.

I’m seeing online listings from .75/1” to .8/1.2”. Figured someone would have good measurements.

Again, thanks for taking the time to do that.

 

[Macintosh]

Yeah, sorry, dont have an action in a oem stock. But I have measured in the past, and the comb was almost parallel to bore…so both of the figures above seem off to me wrt the difference between comb and butt. Wish I wrote it down now, but Id swear neither figure was even an inch when I measured.