DIY custom Rokstock

[bielenbm]

I have been kicking the idea of making a wood Rokstock. After shooting my wood stock Mark V, I decided that the plastic tikka stock needed to go. I started out with a mesa stock as a basic template for the wood duplicator. I used forms and spray foam to make it more like a Rokstock. This is my first stock build ever and I don’t have an actual Rokstock so I’m just going off pictures for the design.

 

[bielenbm]

Im getting close but probably not haha the butt end hast a lot of work left


The inletting is okay but there was much to be left desired. This was my first job with the duplicator, so I had a few oops along the way

 

[waspocrew]

Looks good! I can't even cut a 2x4 straight.

 

[bielenbm]

Looks good! I can't even cut a 2x4 straight.

Haha, well my rough practice attempt with poplar, I forgot to check the router bit depth compared to the follower. The whole stock was 1/4” narrower than it should have been…

 

[Shaymos94]

I also just started my first ever stock build.
Ide love to have Mike build me a rokstock lite but I can’t warrant the 2k. Figured how hard could it be
This is my first attempt with some scrap wood from work,just using some basic power tools. Waiting on a bedding kit a recoil pad. Stain/finish
Picked up a little walnut, already scheming on round 2.
Anyway if you dig deep enough in the rokstock/rokstock lite forum. You’ll find all the dimensions you need to get you close

 

[bielenbm]

I am getting pretty close. I’ll hopefully get to bedding the actions tomorrow. I would be curious to see how close my is to the real thing.

 

[bielenbm]

I also just started my first ever stock build.
Ide love to have Mike build me a rokstock lite but I can’t warrant the 2k. Figured how hard could it be
This is my first attempt with some scrap wood from work,just using some basic power tools. Waiting on a bedding kit a recoil pad. Stain/finish
Picked up a little walnut, already scheming on round 2.
Anyway if you dig deep enough in the rokstock/rokstock lite forum. You’ll find all the dimensions you need to get you close

Haha I would love to have one of his someday. Same here already thinking of doing the lite version next. This one is going to be around 36oz

 

[Shaymos94]

I like the stippling, I think you’re pretty dang close to the real thing. on this one I’ll do some ground up walnut shell or somethin in the clear coat for a little texture on the grip/forend/lower buttstock I’m trying to sell some gear to warrant buyin a set of tools to learn how to do some checkering. I might have a bad habit of over committing to hobby’s.
I haven’t weighed mine yet, the scrap wood I used was 1”x6” rift sawn white oak, which isn’t really great for stocks to begin with,but also particularly heavy. Ide prefer to end up around 30-35oz anyway. We’ll see. It’s all just a practice run anyway.
Ide like to see your project all wrapped up.