I have a custom 6.5PRC I have been debating on listing but I rarely shoot it. Just under 100 rounds through it. It shoots factory Hornady eld-m sub moa (groups are usually around 0.61” and Nosler AB the same) and eld-x just under an inch. I have not reloaded for it yet but do have all the components. Weight is 8.2 lbs on my scale without scope. See below. I did take it out this year and killed a doe at 363 yards with factory ABs.
Bighorn TL3 SA DLC
Proof sendero CF 24" 1:8 threaded
Triggertech Special
Redsnake dbm
Manners EH6A 13.5 lop
Area 419 hellfire brake
The smith work was done by the late Bill Young in NC. The bottom metal and action have been bedded.
I do have an action wrench and standard bolt head as well (new) so you can have another barrel spun up and change it in a matter of minutes.
***ONLY AVAILABLE TO THE BUYER ***
I have 3 boxes of virgin 6.5 PRC ADG brass & two sets of dies (Redding & RCBS). If the buyer close to central KY I have some RL26 unopened that I can make a package deal with.
Scope/rings and bipod not included.
$3200- Gun Only shipped/insured
No trades
Bighorn TL3 SA DLC
Proof sendero CF 24" 1:8 threaded
Triggertech Special
Redsnake dbm
Manners EH6A 13.5 lop
Area 419 hellfire brake
The smith work was done by the late Bill Young in NC. The bottom metal and action have been bedded.
I do have an action wrench and standard bolt head as well (new) so you can have another barrel spun up and change it in a matter of minutes.
***ONLY AVAILABLE TO THE BUYER ***
I have 3 boxes of virgin 6.5 PRC ADG brass & two sets of dies (Redding & RCBS). If the buyer close to central KY I have some RL26 unopened that I can make a package deal with.
Scope/rings and bipod not included.
$3200- Gun Only shipped/insured
No trades
