Convince me to shoot monolithics again

At 250y it is doing 2400fps. That works.
Below 1,800’ish fps impact- extremely narrow winds barely above caliber size most of the time. At 2,000fps sometimes caliber size, sometimes 1/2”.
Yep. 2400fps is a good minimum to avoid disappointment.
 
I haven’t seen this mentioned but another factor with Monos is twist rate. Faster twist rate barrels that put more rotation spin on the bullet result in the same bullet opening up more at an equivalent velocity. This has been shown in gel testing.
 
The mono’s that shed the front section in pedals are pretty devastating. I think I’ve loaded for about 20 deer kills at this point with that design of bullet. From .22 to .308 caliber bullets. From 80 yards to 550 yards. Sub 200 yards we often get petal exits radiated about 4-5 inches around the center. The first moment the petals break off appears pretty devastating in the wound channels we’ve seen. The radiated petals do more damage than you’d expect for their weight. Some higher bc options out there including the hammer hbc line or cutting edge lasers. I only have experience with the first. We did note that the new hbc line expands more quickly and violently this season.

The speed vs bc payoff for the hammers pencils out for my use. I haven’t had the bc impact my effective hunting distance goals for a setup. 700 for creedmoor and 400 for .223. Haven’t lost an animal using monos and there were a couple iffy shots in there. The petals can really buy forgiveness cutting through.

I like only killing the animal I’m shooting at and not having to worry about it with the kids. Also cnc bullets are very consistent so easy to load with.

Entrance and exit with a .223 mono.
 

Attachments

  • IMG_2188.jpeg
    IMG_2188.jpeg
    652.3 KB · Views: 8
  • IMG_2194.jpeg
    IMG_2194.jpeg
    670.3 KB · Views: 8
Back
Top