Canyon pounder knob contacting quivilizer

[Barnhill06]

Anyone had this issue or am I installing it wrong? Cannot tighten the sight down completely.

 

[realunlucky]

@Howard Mee had this setup I believe hopefully he can chime in

Sent from my SM-G996U using Tapatalk

 

[Trial153]

Take a dremil to it …

 

[Howard Mee]

Anyone had this issue or am I installing it wrong? Cannot tighten the sight down completely.

That’s a different set up than mine but give me a few minutes


Sent from my iPhone using Tapatalk

 

[Howard Mee]

Anyone had this issue or am I installing it wrong? Cannot tighten the sight down completely.

Can you post a picture that gives more details. Zoom out and let me see more?


Sent from my iPhone using Tapatalk

 

[Howard Mee]

My setup is entirely different but still, give me a minute or two


Sent from my iPhone using Tapatalk

 

[Howard Mee]

Anyone had this issue or am I installing it wrong? Cannot tighten the sight down completely.

You need to point the quiver mount the opposite direction. Currently pointed left in the photo. Make it point to the right.
It’s upside down.
If you look at the bottom of the quiver bracket (in the photo), it’s flat. Rotate your quiver mount 180 so the flat edge is “up” in the photo.




Sent from my iPhone using Tapatalk

 

[Barnhill06]

Outside. Inside in come into contact with the micro tuner bar

 

[Howard Mee]

Dang it


Sent from my iPhone using Tapatalk

 

[Howard Mee]

Driving into work right now. Give me another hour or so.


Sent from my iPhone using Tapatalk

 

[Barnhill06]

You need to point the quiver mount the opposite direction. Currently pointed left in the photo. Make it point to the right.
It’s upside down.
If you look at the bottom of the quiver bracket (in the photo), it’s flat. Rotate your quiver mount 180 so the flat edge is “up” in the photo.




Sent from my iPhone using Tapatalk

 

[Barnhill06]

Like this. Then the sight is cannot slide back and it still contacts the quivilizer mount

 

[Barnhill06]

Assuming by this pick u prob run the set screw and not the knob with this set up.

 

[Howard Mee]

Oh perfect! A set screw. Sweet. Problem solved!


Sent from my iPhone using Tapatalk

 

[TX_Diver]

Ace hardware probably has a set screw that would replace that knob, unless you need the ability to quickly release it.

Or e-mail option archery. They are both option products so presumably they'd interface well and there should be a solution?