Breakthrough suppressor cleaner

[83cj-7]

If anyone has seen this product and wondered how it works, let me tell you, it’s amazing. Over the years I’ve tried just about everything including “dip”. I’ve never had a suppressor clean so easily.

This is before and after. 12 hours soaking and everything inside just fell off.

 

[RWT]

Post a link to the product

 

[83cj-7]

Amazon.com

 

[peterk123]

If anyone has seen this product and wondered how it works, let me tell you, it’s amazing. Over the years I’ve tried just about everything including “dip”. I’ve never had a suppressor clean so easily.

This is before and after. 12 hours soaking and everything inside just fell off.

View attachment 987998
View attachment 987999
View attachment 988000
View attachment 988001

22lr?

 

[83cj-7]

No, this was an Omega 300 that lived on a 6.5 GAP.

 

[Lawnboi]

Better than clr?

 

[83cj-7]

Yes

 

[justin davis]

Wow that’s impressive. I always use CLR. But this looks good

 

[wind gypsy]

Dang! I've only used that breakthrough kit once and it didn't get that clean but it did work well.

 

[FB Trout]

I’ve used this product as well, it is awesome. One of the main benefits is that it can be used on stainless suppressors, which CLR can be a problem for, or so I’ve read. The breakthrough is amazing stuff!

 

[buckleyboy]

I agree re Breakthrough. It is worth investing in a kit…and then a gallon of it!

I also flush my HUB suppressors with the garden hose adapter that Otter Creek Labs sells. Probably overkill, but it gives me warm fuzzy feelings.

 

[Sundodger]

Has anyone use an ultrasonic bath to clean their suppressor before? Assuming one picks a reasonable fluid, I guess my only significant concern for a printed can would be of the coating/paint if it has any.

 

[FB Trout]

Has anyone use an ultrasonic bath to clean their suppressor before? Assuming one picks a reasonable fluid, I guess my only significant concern for a printed can would be of the coating/paint if it has any.

I have, it is slow, and takes the finish off, at least on a Sparrow that I have.

 

[83cj-7]

Has anyone use an ultrasonic bath to clean their suppressor before? Assuming one picks a reasonable fluid, I guess my only significant concern for a printed can would be of the coating/paint if it has any.

I have with several different solutions and most of time it removes the coating but doesn’t do a great job actually cleaning the suppressor. This product worked better and faster.