I bought a Bergara B 14 Ridge in 7mm Rem Mag this winter. Taking it on a Newfoundland moose hunt in September. Has anyone figured out which ammo it likes best? I've shot two boxes of cheaper Norma following the barrel break in recommendations. This weekend I tried more expensive Federal Premium Barnes TSX 160 and Hornady Outfitter 150 CX. Both shot about 3 inch MOA. Bergara guarantees less than 1 MOA. Scope is Vortex Viper HD with Talley Lightweight mounts, torqued to specs. Solid sand bag/ bench rest. I called Bergara and they had me check action screws torque, which seemed fine, and disasseble and clean packing grease out of bolt. (It was pretty clean) So before I go spending a bunch of money on trial and error, I thought I 'd see if anyone else has found what they like to eat. Thanks!
Bergara 7mm Rem mag favorite rounds
- Thread starter DaHardy
- Start date
GrayGoose
Lil-Rokslider
- Joined
- May 19, 2020
- Messages
- 192
Try Hornady Precision Hunter ELD-X or Federal Premium Berger Hybrids. Both shoot well for me out of a Bergara highlander 7mm.
Bad part is they have been tough to find lately. Haven't seen a box on the shelf since January.
Bad part is they have been tough to find lately. Haven't seen a box on the shelf since January.
With all due respect, and no slight towards the OP, but I would have someone else shoot it.
Secondly, I'm not sure if they recommend a break in, but you may check on that. I've seen a few guns go from multiple MOA to less than 1 moa after break in.
Sent from my SM-G986U using Tapatalk
Secondly, I'm not sure if they recommend a break in, but you may check on that. I've seen a few guns go from multiple MOA to less than 1 moa after break in.
Sent from my SM-G986U using Tapatalk
Thank you. The ELD X is one of their recommended bullets. However I've seen in other forum threads that a lot of people didn't recommend it for moose. I'll see if I can find some online though.
I have a new bergara hunter in 300WM that was being picky too. It didn’t like Sierra 180s that I found in a factory load or 215 Bergers from unknown munitions. 200 gr accubonds from choice ammo we’re ok, like 1.5 MOA. Then I started working a hand load with 210 ABLRs and it went to tiny little groups, well less than an inch. Not sure if that will translate to 7mm but might be worth a shot if you can find them. Might also verify the scope on a different rifle, that was going to be my next move
So the first thing you should look at when choosing ammo is seeing which bullet is appropriate for your twist rate. The B14 7 mag is a 1:9.5 twist which means it is going to stabilize and shoot the best with the 165-grain area. If you go up to the 180s you are not going to stabilize the bullets, and the 150-grain class will be overtwisting.
So now that we know what bullet range will work the best, see what factory options are offered for that range.
www.midwayusa.com
www.midwayusa.com
www.midwayusa.com
www.midwayusa.com
www.midwayusa.com
Those are the 5 options that I would stick with and go see what you can find. The accubonds will probably hold together a little better if you like high shoulder shots but the ELDX is going to do everything that you need. Depending on how far you are shooting will change how much you test the ammo but those are the starting points.
So now that we know what bullet range will work the best, see what factory options are offered for that range.
Nosler RMEF Trophy Grade 7mm Remington Mag Ammo 160 Grain Partition
Nosler Trophy Grade ammunition is high quality, production-run ammunition manufactured to strict tolerances and inspected as it is hand-packaged. Trophy...
www.midwayusa.com
Nosler Trophy Grade 7mm Remington Mag Ammo 168 Grain Nosler AccuBond
Nosler Trophy Grade ammunition is high quality, production-run ammunition manufactured to strict tolerances and inspected as it is hand-packaged. Trophy...
www.midwayusa.com
Hornady Precision Hunter 7mm Remington Mag Ammo 162 Grain Hornady
Accuracy and terminal performance are the cornerstones of Hornady Precision Hunter factory loaded ammunition. Great care has been given by...
www.midwayusa.com
Federal Premium 7mm Remington Mag Ammo 168 Grain Berger Hybrid Hunter
Federal Premium is quality hunting ammunition designed for maximum performance and reliability. Premium hunting bullets are matched with select powders,...
www.midwayusa.com
Hornady Superformance 7mm Remington Mag Ammo 162 Grain Hornady SST
Superformance ammunition is loaded with proprietary propellants that increase the velocity ratings up to 200 feet per second compared to other popular...
www.midwayusa.com
Those are the 5 options that I would stick with and go see what you can find. The accubonds will probably hold together a little better if you like high shoulder shots but the ELDX is going to do everything that you need. Depending on how far you are shooting will change how much you test the ammo but those are the starting points.
That is really helpful information! Much appreciated.So the first thing you should look at when choosing ammo is seeing which bullet is appropriate for your twist rate. The B14 7 mag is a 1:9.5 twist which means it is going to stabilize and shoot the best with the 165-grain area. If you go up to the 180s you are not going to stabilize the bullets, and the 150-grain class will be overtwisting.
So now that we know what bullet range will work the best, see what factory options are offered for that range.
Nosler RMEF Trophy Grade 7mm Remington Mag Ammo 160 Grain Partition
Nosler Trophy Grade ammunition is high quality, production-run ammunition manufactured to strict tolerances and inspected as it is hand-packaged. Trophy...Nosler Trophy Grade 7mm Remington Mag Ammo 168 Grain Nosler AccuBond
Nosler Trophy Grade ammunition is high quality, production-run ammunition manufactured to strict tolerances and inspected as it is hand-packaged. Trophy...Hornady Precision Hunter 7mm Remington Mag Ammo 162 Grain Hornady
Accuracy and terminal performance are the cornerstones of Hornady Precision Hunter factory loaded ammunition. Great care has been given by...Federal Premium 7mm Remington Mag Ammo 168 Grain Berger Hybrid Hunter
Federal Premium is quality hunting ammunition designed for maximum performance and reliability. Premium hunting bullets are matched with select powders,...Hornady Superformance 7mm Remington Mag Ammo 162 Grain Hornady SST
Superformance ammunition is loaded with proprietary propellants that increase the velocity ratings up to 200 feet per second compared to other popular...
Those are the 5 options that I would stick with and go see what you can find. The accubonds will probably hold together a little better if you like high shoulder shots but the ELDX is going to do everything that you need. Depending on how far you are shooting will change how much you test the ammo but those are the starting points.
Pharmseller
WKR
Keep in mind that rifles are like fingerprints, no two are exactly alike. Just because 162 ELDX with Reloader 26 shoots great in my Bergara doesn’t mean it will shoot great in yours.
(I don‘t have a Bergara, I shoot Tikkas, but the message translates.)
And barrel break in is a myth. Seriously.
(I don‘t have a Bergara, I shoot Tikkas, but the message translates.)
And barrel break in is a myth. Seriously.
Pharmseller
WKR
That would be quite a trick, given that Nosler doesn’t make a 7mm AccuBond in 165 grains.
P
That would be quite a trick
160^*
Thanks! And I've heard they are great big game bullets. Now to find any for sale......
Much better groupings today, with the same bullets. I removed the stock and sanded the paint/coating off of the lugs. I made sure the action bolts were torqued to spec. I also noticed my muzzle brake wasn't tight so I made sure that was tight. And I only shot three and let it cool. 1" MOA with both the Hornaday Outfitter 150 and Federal Premium Banes TSX 160s. I tried adding a 4th and 5th shot and they were not as tight. Thanks for the help.
DJL2
Lil-Rokslider
- Joined
- May 22, 2020
- Messages
- 268
If I were going to shoot a copper mono from a 7mm RM, I’d grab the Barnes VOR-TX loaded with their 139 grain LRX. That should be a decent performer out to 300 yds or so depending on your MV and elevation, maybe a little further at a push. My experience with that ammo was positive in terms of both accuracy and consistency.
If longer range was on the table and lead core was an option, I’d grab 162 ELD-X. If I was going to hand load, I’d grab 160 TMK or 162 ELD-M. All should stabilize without issue and have more than enough starting MV out of the 7mm RM to be effective much further than even a reasonably skilled hunter can make a shot,
If longer range was on the table and lead core was an option, I’d grab 162 ELD-X. If I was going to hand load, I’d grab 160 TMK or 162 ELD-M. All should stabilize without issue and have more than enough starting MV out of the 7mm RM to be effective much further than even a reasonably skilled hunter can make a shot,
Similar threads
Featured Video
Latest Articles
- What Do Elk Eat? Elk Nutrition, Habitat, and Finding More Elk with Luke Schultz
- Patagonia Nano Air Ultralight Hoody Review
- CWD: Progress and Hope in Wyoming?
- Zeiss Conquest Apia 20-50×65 Spotting Scope Review
- What does 2026 hold for Wyoming’s Mule Deer hunters?
- Mathews ARC Bow Review
- What the Mule Deer Conservation Strategy Reveals About Wyoming’s Future
- West-wide Snowpack & Precipitation Update with Josh Boyd
- Leica PRS 5-30x56i Field Review
- Backcountry Mule Deer Hunting with Braxton Hamilton & Storie Ratcliff