Attaching Grabit-It II to Duplex frame with Nomad

[buckeyearcher]

I have a duplex frame with a nomad bag. Attaching my grab-it in lower mount point is no problem but I can't seem to figure how to attach it in the upper mount position. It seems as if my frame might be even missing a common loop in the upper position. Am I over looking something?

 

[castandblast]

Yeah, my frames do have common loops higher up as well as at the bottom.

 

[rhunter424]

I'm in the same boat as you. I have an older G2 duplex without common loops in the middle and on top.

You could make it work by putting two split bar ladder locks on the tab loops and run the grab it through there.

 

[buckeyearcher]

I'm in the same boat as you. I have an older G2 duplex without common loops in the middle and on top.

You could make it work by putting two split bar ladder locks on the tab loops and run the grab it through there.

How old is your frame? Bought mine in 2012.

Looks like I might have to call Kifaru next week and see what they suggest.

 

[rhunter424]

How old is your frame? Bought mine in 2012.

Looks like I might have to call Kifaru next week and see what they suggest.

2012 as well

 

[mrbillbrown]

Throw a pair of k-connectors on your grab-it and use the g-hooks for attachment. I run them on everything I have that needs attachment. They are much nicer than messing with the 3bar sliders and common loops.

 

[rhunter424]

I bet putting a k clip would also work similarly to a common loop.

 

[yota4by4]

How old is your frame? Bought mine in 2012.

Looks like I might have to call Kifaru next week and see what they suggest.

If you call Kifaru, please post suggestions...

Thanks,

Lou

 

[RCR]

I was trying to attach an older pocket to my Nomad and I came up with a simple solution (probably not new, just new to me). Take a look at the pics and you'll get the idea pretty quick.
View attachment 25841View attachment 25842

 

[yota4by4]

I was trying to attach an older pocket to my Nomad and I came up with a simple solution (probably not new, just new to me). Take a look at the pics and you'll get the idea pretty quick.
View attachment 25841View attachment 25842

Pics are not showing up for me...

 

[RCR]

Pics are not showing up for me...

Interesting. They were there for a while. Here they are again. This solution will allow you to place a common loop anywhere you have a Molle type attachment point.

View attachment 26097
View attachment 26098View attachment 26099