Adjusting custom CDS dial?

[texasproud11]

I did all my sighting in, put on my cds, and it was shooting low. After 2 clicks I was on and need to adjust now but my dial is stuck on there. Any tips?

 

[huntsman22]

Just leave it. Next time you shoot, it'll be off 2 clicks the other way.After all, it IS a CDS Leupold......

 

[Steve from GA]

I did all my sighting in, put on my cds, and it was shooting low. After 2 clicks I was on and need to adjust now but my dial is stuck on there. Any tips?

I might be missing something here. Are you saying that your CDS dial is 2 clicks off at your zero range? If so, let's say you have your original dial on and you zero the rifle. Now you put the CDS dial, fire your rifle, and it takes 2 clicks to get your CDS hitting the bullseye.

So at this point, your CDS is 2 clicks from the zero setting but it's hitting dead on, right? Now remove the CDS dial, and place it back on the scope so that your turret zero range is over the witness mark and your dial clicks into place. Your CDS dial should now be hitting dead on at your zero range with zero clicks needed.

Of course, from there you should check your drops out to other ranges. Again - I may be missing a crucial piece of information here. I would also ask the obvious question, are you shooting under similar conditions that you gave when you ordered the dial?