I have a Duplex Frame with aluminum stays in the "normal" curve configuration and I am feeling quite a bit of pressure on the top of the lumbar pad and unless I really crank down the waist belt, the bottom of the lumbar pad barely touches my back.
Who has adjusted the bend of their frame on their own to get the fit just right?
I figured out how to access the frame stays, but they are really tight in the frame slots? If I pull them out will they fit back in?
Would I be better off to swap them for the "mid-flatback" or "flatback" stays?
I have played around plenty adjusting Badlands and Eberlestock frame stays and have had good results but the Kifaru stays are beefier, for sure. Don't want to bite off more than I can chew...
Who has adjusted the bend of their frame on their own to get the fit just right?
I figured out how to access the frame stays, but they are really tight in the frame slots? If I pull them out will they fit back in?
Would I be better off to swap them for the "mid-flatback" or "flatback" stays?
I have played around plenty adjusting Badlands and Eberlestock frame stays and have had good results but the Kifaru stays are beefier, for sure. Don't want to bite off more than I can chew...