7mm PRC 20" mono bullet choice

[finner]

Does anyone have any beta for a short barreled 7prc with monos? Looking to try the PVA Cayuga in 151 or 170, the CE Lazer in 160 or some flavor of Hammer.

Goals are 750yds and in on muleys. I have H1000, RL23 and H4831sc on hand with 215s and ADG brass.

 

[WKR]

Apex Afterburner 147 grain is on my list

 

[IrkedCitizen]

You have the best ones on your list. Cutting edge would likely be my first choice followed by PVA then hammers.

 

[finner]

Anyone have a solid load for a CE 160 or 145?

 

[WKR]

Anyone have a solid load for a CE 160 or 145?

Cutting Edge Bullets- Load Development Results

Hi all, this is the designated thread for those who are participating in the Cutting Edge Bullets giveaway. We figured it would be best to have a centralized location for everyone to share their results and discuss. This thread is for the load development portion. The terminal performance part...

www.longrangeonly.com

Check in that thread, seems like there are more CE shooters over there

 

[punklife505]

Does anyone have any beta for a short barreled 7prc with monos? Looking to try the PVA Cayuga in 151 or 170, the CE Lazer in 160 or some flavor of Hammer.

Goals are 750yds and in on muleys. I have H1000, RL23 and H4831sc on hand with 215s and ADG brass.

I'm a fan of Hammer and have seen Cutting edge bullets that have rolled over rather than open and break apart at high velocities.

 

[wind gypsy]

Anyone have a solid load for a CE 160 or 145?

Not in PRC but 22" SAUM load had 145 lazers around 3030 fps over h4350. Should be able to push them at least that fast from a 20" PRC.

 

[finner]

Not in PRC but 22" SAUM load had 145 lazers around 3030 fps over h4350. Should be able to push them at least that fast from a 20" PRC.

Thanks! Did their published BC hold up?

 

[wind gypsy]

Thanks! Did their published BC hold up?

Never shot them far enough to test BC but Applied ballistics has a curve and rated BC for them and CEB has the AB G7 on their website. i have no reason to think the AB tested #'s would be wrong.

 

[SemiProRoadHunter]

I’ve tried 145 and 160 lazers in mine and couldn’t get them to shoot well. I’m playing around with 160 and 168 coppers roses right now, they both shoot fine. I’ve only shot one animal with a 160 copper rose and it performed fine for a mono. I haven’t done any testing as far as validating the BC though.

 

[wildernessrimfab]

Seekins Havak Element 7PRC 22" barrel with suppressor. I am getting 3070 MV with 155 hammer hunters using H1000, Fed 215, and ADG brass. Hit pressure around 3150 but settled on a nice node at 3070. Just punching paper with this bullet so far, but shoots 5 shots under 0.5 MOA. Extreme Spread mid teens SD below 10.

Have not yet trued BC past 300 yds.

Very easy load workup. Tried H4831SC but was slower with worse accuracy.

Hope that helps