300 PRC Nosler 200gr Accubonds

[Customweld]

I’m having a hard time finding a recipe for 200gr accubonds. I just picked up the rifle and am wanting to start working up some loads. Does any one have a good starting recipe? I’m not committed to the accubonds, I just have a bunch left over from a 300WM. Figured I’d give them a go.

 

[Mojave]

It holds somewhere around 3-7 more grains of powder than the 300 Win does. But it doesn't seem to be quite as fast in my two rifles. SD is lower though.

I would use Norma powder. I have German powder here in German, and I don't think it is imported to America.

 

[TaperPin]

I’ve used the Nosler 210 gr data with H1000 - as always starting low and working up - you might get an extra few grains before pressure signs, or you may not.

 

[Customweld]

I’ve used the Nosler 210 gr data with H1000 - as always starting low and working up - you might get an extra few grains before pressure signs, or you may not.

View attachment 828655

I was wondering if folks just were just using this for a starting point. Thanks!

 

[waspocrew]

I was wondering if folks just were just using this for a starting point. Thanks!

Which powder are you looking to use? Check out Hodgdons site - click the right buttons and it'll show you 200 gr data with several powders.

Reloading Data Center – Hodgdon Reloading Data Center

hodgdonreloading.com

 

[Customweld]

Which powder are you looking to use? Check out Hodgdons site - click the right buttons and it'll show you 200 gr data with several powders.

Reloading Data Center – Hodgdon Reloading Data Center

hodgdonreloading.com

Thanks @waspocrew! I’m going to start with H1000. I should have looked a little harder! Appreciate it.

 

[TaperPin]

I was wondering if folks just were just using this for a starting point. Thanks!

Should be a fun gun!

That usually gets you close enough. Hodgdon’s max is 1.4 gr higher than Nosler’s 210 data, which is about what I’d expect.