Search results

  1. D

    Lands evaluation

    This is a 7 mm Remington Magnum that we've had some accuracy issues with. The kahles getting fixed ended up being step one after we figured out the scope was an issue. 150 grain soft points off the shelf and some 120 grain Nosler ballistic tips that I hand loaded with IMR 4198 shoot the same...
  2. D

    AR10 .243 & Berger 108gr elite hunters

    Has anyone else had issues with the bullet hitting the bottom of the chamber hole with these long bullets? tried poly and metal mag. it just ended up jamming the tip into the barrel hole face. it appears the slenderness is causing the tip to touch because the bullet isnt pointing up soon enough...
  3. D

    Bolt action options

    .223/wylde, 20-24" barrel & threaded, want something to handle the 75-80gr long bullets and can be loaded into the lands/rifling if desired. Prefer a good trigger obviously, even with a few dollars or some time to make it happen is ok. I want a stock that is either already floated or can handle...
  4. D

    Rifle support for load development

    Dad has a browning A bolt 7 rem mag with the boss "brake". Last shooting session we determined the Swarovski was bad. Hes got his old pentax on it that it sported years ago. We were using a old metal caldwell type sled. The recoil was a bit much on his shoulder after a bit. Yesterday we started...
  5. D

    Backfire - Burris walkthru

  6. D

    AR barrel brand

    I might want to replace the cheap 6.5cm barrel with something better. Im looking for feedback on brands/profile. Its going to be suppressed always. Its going to be fed 147gr eldm off the shelf primarily.
  7. D

    OTM vs TMK

    I happened to already have several boxes of sierra OTM in 6.5cm and .308. I think i have seen OTM talked about not being as reliable on deer as the TMK, but i could not find the info to verify. Are they good to go or should i keep them for steel plates?
Top