Recent content by Schwarz06

  1. S

    Black Timber Outfitters NM/Colorado

    No it’s definitely black timber outfitters. Their main office is in Utah but they guide all the four corner states.
  2. S

    Is LC brass "Good" brass?

    LC brass is good quality. As stated previously, the capacity is much different. I find that Federal and LC brass generally have pretty close capacity being much lower than Remington or Hornady. You will get to pressure MUCH sooner so back down 10 % off of max and rework your load. I'll also...
  3. S

    7mm Rem Mag T3x SuperLite

    My Tikka 7 Rem Mag load is a 160 Accubond, RP brass, CCI 200 and 72 grains of MagPro. Bullet seated at Mag length. 3.330 COAL. If I recall, velocity is around 2950.
  4. S

    6.5 PRC Reloading Success

    Mind sharing your powder charge? And also distance to lands if you happen to know. I've been tinkering with this exact load for a while with very limited success. Right when I think I have a load worked up I make up the same load to verify and it falls apart.
  5. S

    7mm rem mag powder

    Ive got a solid load for my tikka of 72 grains of magpro under a 160 accubond. This is a max load work up to it. But tikkas also have a mile long throat so pressure generally comes over max.
  6. S

    Best whitetail bullet for a short barreled 6.5 CM?

    I've had really good luck with the 129 Nosler ABLR. Haven't recovered a bullet yet. Plenty of punch at close range but still do the job out at distance too. I run them out of an 18.5 inch sig cross.
  7. S

    Having, or still dreaming of a white Christmas? [emoji1]

    Yea it was 50 degrees for Christmas in my area of NY. Deer season was tough with no snow.
  8. S

    Black Timber Outfitters NM/Colorado

    Merry Christmas all. I'm looking at a possible 2024 or 2025 elk hunt in NM or CO. A friend who lives out that way mentioned Black Timber Outfitters. Was wondering if anyone has any insight or experience?
  9. S

    Question on Kimber Hunter Pro Desolve

    I know it’s an old thread but if you check kimbers website it says 9 Twist. I have the same gun and it shoots great with 162 eldx and 160 accubonds. That’s all I’ve put through it.
  10. S

    Pillar Bed an X Bolt

    I've got an X Bolt Hells Canyon Long Range in 7mm Rem Mag. I've done a significant amount of load development and just cant seem to lock down on consistency. It will shoot a half MOA group and then turn around and shoot a 2 MOA group usually stringing vertically. To me its acting like the...
  11. S

    XBolt HCS observations

    I'm interested in hearing about the pillars if you end up doing that. I have the HC Long Range in 7mm Mag and I'm having a bit of vertical issue so I'd like to see what pillars might do its just that there's not much meat for the rear screw.
See more

Latest posts

Featured Video

Stats

Threads
323,148
Messages
3,392,987
Members
75,130
Latest member
Brian Wood

Latest Articles

Top