Timberghost
WKR
- Joined
- Mar 29, 2013
- Messages
- 308
Hey boys, I recently purchased a tommy hogg from one of the members here. Now this is my first slider sight.
So I need some advice. It is a 3 pin. So from the reading I have done I should sight my 3 pins to 20,30 and 40 and my bottom pin will be my adjustable one. That's about as much as I know for sure.
So where do I start the wheel? As high as possible or do I line it up so my peep is inline with my sight housing? I am thinking I will make my own sight tape marking once I have the 3 pins set up.
So basically any and all tips and advice would be much appreciated.
My bow is shooting about 272 fps. And only 8 percent FOC. If I am going to be shooting for practice at longer ranges will that be good?
Thanks in advance, rob.
So I need some advice. It is a 3 pin. So from the reading I have done I should sight my 3 pins to 20,30 and 40 and my bottom pin will be my adjustable one. That's about as much as I know for sure.
So where do I start the wheel? As high as possible or do I line it up so my peep is inline with my sight housing? I am thinking I will make my own sight tape marking once I have the 3 pins set up.
So basically any and all tips and advice would be much appreciated.
My bow is shooting about 272 fps. And only 8 percent FOC. If I am going to be shooting for practice at longer ranges will that be good?
Thanks in advance, rob.