Tommy Hogg Dial Movement

Joined
Jun 4, 2014
Messages
1,163
Location
North Dakota
I made some tweaks to my setup and need to get everything dialed in again. While making adjustments to the sight, I noticed that the dial will move when I engage the lock. I was shooting 60 yards, and adjusted the dial to "H" on the tape. When I locked the dial, the pin would move 1-1.5 letters in either direction. Now I'm assuming that these dials have some sort of gear in them, but that seems like a lot of movement in between the teeth of the gears.

Obviously, not locking the site would be the simple solution, but I'd still like to use the lock when sighting in or shooting 3d.

Has anyone else had issues with this?
 
OP
ndbwhunter
Joined
Jun 4, 2014
Messages
1,163
Location
North Dakota
I think I may have figured it out. I'm guessing the micro adjust dial below the big dial is not set to zero. That would explain the issues I'm having.
 
Top