Sold Tikka 6cm prefit, brass, dies

Status
Not open for further replies.
Rating - 100%
32   0   0
Joined
Oct 5, 2014
Messages
1,218
Location
Los Anchorage, AK
Preferred 6mm creedmoor shouldered tikka prefit. 156 rounds on it. See pic for specs. 99 pieces of 1-2x fired Alpha LRP brass. Hornady seating die, custom honed Forster FL die, and hornady lock-n-load modified case. $spf tyd for everything. Not willing to split it up at the moment, unless the brass and dies go first.
bc261f572a0ffa94f2a58229dbea9c51.jpg

16afe0f4a768b924044aa0bb58efae33.jpg
 
Last edited:
OP
C
Rating - 100%
32   0   0
Joined
Oct 5, 2014
Messages
1,218
Location
Los Anchorage, AK
What bullet did you shoot with it? Weight on barrel?

I shot a box of factory eldm which grouped great. The rest were 95gr DRT terminal shock which I could barely get below 2 moa. I think the 7 twist is just a little fast for them. Killed a couple elk though.

I didn’t weigh the barrel before I installed and haven’t taken it off yet. I was going to leave it on until it sells but if that’s the deciding factor for some I can remove and weigh it.
 
Status
Not open for further replies.
Top