Remington 700 - Bedding?

[160andup]

I have a 700 BDL in .270 that has never shot overly well. Not approaching MOA. It's not free floating, Remington intentionally has a significant amount of contact on the front end of the stock. Anyone bed these to help improve accuracy? Could there be something else causing this? Figured I would try bedding it to see if that helped... Open to any opinions from folks that know more than me...

 

[LaHunter]

You can use sandpaper and a wooden dowel to remove that contact area from the barrel channel of your stock easily to 'free float' your barrel. After doing that you can test to see if the groups improve. If you have the factory plastic / 'tupperware' stocks, I would not waste my time or money bedding that stock. I prefer HS Precision stocks, but there are many options for good aftermarket stocks that can be bedded. If you have the original wood stock, I would just replace it with an aftermarket stock rather than modifying it, but that's just my opinion.

 

[Castle Rock]

Remingtons generally shoot very well, bedding them is easy and helps consistency.
They are much maligned here, but unless you make a habit of burying your rifle in the snow I can’t think of a long action rifle I like better and the 270 is a giant killer

 

[Tmac]

I have a 700 BDL in .270 that has never shot overly well. Not approaching MOA. It's not free floating, Remington intentionally has a significant amount of contact on the front end of the stock. Anyone bed these to help improve accuracy? Could there be something else causing this? Figured I would try bedding it to see if that helped... Open to any opinions from folks that know more than me...

You might be able to test if removing the front pressure point helps with small nylon washers or pierces of a credit card like material. Put them between the stock and action screws. That way if it makes it worse you still can go back to the pressure point easily. But if it is shooting real bad with the pressure point no sense in keeping it there.

I had a couple Rem700 that free floating did not help, but full length bedding did help. I took out enough stock material to fully free float then epoxy bedded the full length of the action/lug/barrel. Both were 22” thin taper barrels, mountain rifle thin but in ADL style with plastic stock.

I’ve had good luck with HS Precision stocks in factory 700’s with their sporter type taper barrels too.