Primers Seating Very Hard All of A Sudden

[Yodie]

22 GT, Alpha brass, 2x fired. This is 3rd time to seat primers in them, first two times went smoothly. Now that I’m trying to prime them now they are so tight it’s flattening the primers to get them seated.

Same priming tool I’ve used for the previous 200 priming on these cases.
Cases were deprimed, wet tumbled with stainless pins, dried, lubed, annealed, sized, walnut vibratory polished, blown off with air gun, now trying to prime and running in to this.
Same primers, Remington 7 1/2
Primer pockets are shiny clean, no obstructions, no carbon ring.

Thought it might be my Frankford hand priming tool, tried priming a random 6.5CM Lrp, 357 magnum spp, and a 41 magnum lpp, all went in smoothly with minimal effort.

I’m stumped on why they lockers got so tight that I can’t properly seat them.

 

[HandgunHTR]

Do you have a primer pocket uniforming tool?

If not, get one. It will ensure that your pockets are in spec.

Not sure exactly why you are having issues. Are the primers from the same lot?
It could be very slight peening of the mouth of the pocket during wet tumbling.

 

[WeiserBucks]

It could be very slight peening of the mouth of the pocket during wet tumbling.

This is likely.

 

[Lawnboi]

If it’s from peening a cutter for removing primer pocket crimps will probably work.

Stainless pin tumbling does the case no good.

 

[TaperPin]

Same lot of primer? Remington is making primers as fast as they can and it wouldn’t be unreasonable to guess they might cut more corners now than during normal demand. I’d measure the primer cup to the side of and on top of the anvil and compare them to another lot.