New PRS shooter, MDT chassis issues

Joined
Dec 29, 2021
Messages
49
New shooter about to go to my second match. So I’m running a tikka ctr 20” 6.5 cm in a mdt acc gen 2. I have encountered two issues with it so far, first I can’t seem to get it to balance with the factory barrel. I have the internal weights and 2 externals as far forward as I can mount them and a Harris bipod out front and it still is balancing right on the mag well with an area 419 brake. If I a run my suppressor, it balances about 3” infront of the mag well which seems much much better from my practicing sessions. Would you run the can and give up some recoil management in exchange for the better balance? Second issue is this is my first experience with center fire chassis system. This thing feels like banging two pots together when it goes off. The rifle still hammers, everything is tight, but the vibrations are nuts compared to the wood stocked rifles/McMillans I have always used in the past. Is this normal? I have ordered the “jellies” from mdt and I’m hoping they make it in before the next match. Is there anything else that can be done if these dampeners don’t fix the twang?
 

Attachments

  • IMG_9322.jpeg
    IMG_9322.jpeg
    639 KB · Views: 19
Balance is going to be tough with a light and short barrel.

A 24” MTU or heavier will settle things down quite a bit.

I stopped using brakes for PRS a couple years ago. A straight suppressor is a disadvantage but if you’re a beginner I’m not sure it’s going to make as much of a difference; I’d take the setup that you can get steady easy and break good shots with.

I don’t notice any twang when shooting, even on a similar setup to you, but I’m shooting a gen 1 acc
 
What lawnboi said. I think the gen2 is actually the version that is least ass heavy. Only other thing I can think of is putting stackable mlok weights at the very front like these dependabilt ones. https://www.sawtoothrifles.com/product/dependabilt-sidetrak-weights-stack-hardware/

MDT makes a “tip weight” for the gen 2s as well. It’s not much weight unfortunately but it would allow stackable mlok weights to be further forward too.

By the time you buy all that weight you’re approaching the cost of a heavier barrel blank.

My gen2 doesn’t feel bad to me as far as vibe goes but it’s also a fair bit heavier than your rifle with a fuzion action and 28” MTU contour plus suppressor and some chassis weights.
 
Much appreciated guys. It’s being rebarreled right now in a krieger mtu gonna be a 6 gt. Despite all the stacked weights and everything I couldn’t get the factory tube to balance. Besides I was looking for an excuse to rebarrel anyway
 
Back
Top