Hoyt Helix help

[87TT]

Can someone please give me the measurements of the inside and outside dimensions on the top and bottom limbs? I have one coming and need to adjust the design of my press. I know the top and bottom are different and the bottom is wider I believe. Really appreciate any help. I am cutting it close on elk season and would like to get as much done before UPS delivers it.

 

[wayoh22]

Thought that info would be in the tune charts but couldn't find anything. Call Hoyt and ask tomorrow if no one can get those measurements to you in a reasonable amount of time

 

[87TT]

You would think you would call but they don't publish a number and you can only email them and they say that they have an extreme volume of inquiries and "may not" answer.
Just hoping someone here has one and can measure it for me. Otherwise I will have to wait for mine to arrive and the modify my press. Just trying to save time that I'm running out of before the season (Sunday).

 

[fatlander]

Just measured my RX3 turbo

Top: 2 5/16” and 13/16”

Bottom: 2 13/16” and 1 3/8”


Sent from my iPhone using Tapatalk

 

[87TT]

Should be the same thanks

 

[Joyce]

Just measured my RX3 turbo

Top: 2 5/16” and 13/16”

Bottom: 2 13/16” and 1 3/8”


Sent from my iPhone using Tapatalk

Interesting...

I just measured my Helix Ultra and all the measurements are the same except the inside bottom which is 1 5/16". I measured on both sides of the rocker with the same result.

 

[87TT]

My press has 1/2" rails that press the limbs. Using your measurements, the lower limbs are about or at 3/4" wide. So if I make the space between them 1 5/8" then they should land about dead center on the limbs.

 

[Joyce]

Sounds like it'll work just fine. Good luck getting it back together and tuned before the opener!

 

[87TT]

Brand new in the box bow. So I hope it goes as easy as they say.