DIY stocky's VG flush pic rail

[snopro176]

I've been staring at the mill at my work for a long time now and the other day I finally clamped my stockys VG in and went for it. Used a 5/8" 4 flute end mill bit and went down a total of .400" from the sling stud hole and made passes outward until the pic rail fit. Was doing .050" at a time because I was being a puss, did .100" towards the end with no issue. It came out great. I got to still use the OG sling stud thread for 1 bolt and added a rivet nut for the other. I then spread a thin layer of black epoxy over the whole thing and called it good

Sent from my SM-S921U using Tapatalk

 

[Stache Attack]

I might just have to do this towards my mag with an Arca. Nice work!

 

[snopro176]

I might just have to do this towards my mag with an Arca. Nice work!

Post some pics if you do. The gorilla glue brand black epoxy was not the best. If i did it again, I'd use a pourable acrylic or something.

Sent from my SM-S921U using Tapatalk