DIY custom Rokstock

[bielenbm]

I have been kicking the idea of making a wood Rokstock. After shooting my wood stock Mark V, I decided that the plastic tikka stock needed to go. I started out with a mesa stock as a basic template for the wood duplicator. I used forms and spray foam to make it more like a Rokstock. This is my first stock build ever and I don’t have an actual Rokstock so I’m just going off pictures for the design.

 

[bielenbm]

Im getting close but probably not haha the butt end hast a lot of work left


The inletting is okay but there was much to be left desired. This was my first job with the duplicator, so I had a few oops along the way

 

[waspocrew]

Looks good! I can't even cut a 2x4 straight.

 

[bielenbm]

Looks good! I can't even cut a 2x4 straight.

Haha, well my rough practice attempt with poplar, I forgot to check the router bit depth compared to the follower. The whole stock was 1/4” narrower than it should have been…