Dillon Caliber Conv Help

[Unckebob]

I bought a Dillon 750 to load higher volume cartridges; however, I want to set up a tool head (or tool heads) for decapping and sizing my 6.5CM, 270 and 280AI brass.

Since they all use the same base plate, I figure that I can buy the caliber conversion kit for 6.5 CM (which I might occasional use with a powder dropper and seater) for this project.

Have I got this right?

 

[M16]

Check their conversion chart.

https://www.dillonprecision.com/media/manuals/xl650-caliber-conversion-chart.pdf

 

[Unckebob]

Check their conversion chart.

https://www.dillonprecision.com/media/manuals/xl650-caliber-conversion-chart.pdf

Thanks for the useless response.

The question was whether I could use a 6.5CM caliber conversion kit to decap and size two long action cartridges (270 & 280AI).

You referenced an old chart that predates the 6.5CM.

 

[nhyrum]

If you go to Dillons website, on the caliber conversion page, you can get the new chart.

https://dilloncdn.com/magento/charts/xl750-conversion-chart.pdf

According to this, the 6.5 creedmoor uses a different shell holder than 270 and 280

Sent from my SM-S918U using Tapatalk