Selling a sweet niche product to make space before season. Still plenty of time to mount it and get it dialed for you!
This is a Brux barrel. .284 bore. 1:8 twist. 22” from end of threads to end of threads. Right at 21/32” or 0.66” just before the shoulder. Can’t for the life of me find the scale, but it’s light!
I had all work done by Pierce Engineering (their rep and quality speaks for itself).
I had it chambered in 7mm Sherman Short Mag (7SS) back when I had dreams of going that route. Spiral fluting by them. It’s cerakoted black and threaded 5/8x24 at the muzzle, with a shoulder for your can or brake. It’s chambered to fit my Browning X-Bolt. I’m sure it will screw into yours, but it would absolutely need headspacing to be safe. Seekins thread protector comes with it.
I never had it mounted nor did I shoot it. I had a Proof in 6.5 prc done at the same time and it fit my needs with easier-to-obtain factory ammo. So I’ve kept that one on.
It was a $400+ barrel with easily $500 of work done to it. It’s almost turn-key for your rifle. I do recognize that it’s a bit of a niche product as it sits.
I think asking $250 to get it to sell is reasonable.
Payment via many different means. Contact via PM. More pics upon request.
Sent from my iPhone using Tapatalk
This is a Brux barrel. .284 bore. 1:8 twist. 22” from end of threads to end of threads. Right at 21/32” or 0.66” just before the shoulder. Can’t for the life of me find the scale, but it’s light!
I had all work done by Pierce Engineering (their rep and quality speaks for itself).
I had it chambered in 7mm Sherman Short Mag (7SS) back when I had dreams of going that route. Spiral fluting by them. It’s cerakoted black and threaded 5/8x24 at the muzzle, with a shoulder for your can or brake. It’s chambered to fit my Browning X-Bolt. I’m sure it will screw into yours, but it would absolutely need headspacing to be safe. Seekins thread protector comes with it.
I never had it mounted nor did I shoot it. I had a Proof in 6.5 prc done at the same time and it fit my needs with easier-to-obtain factory ammo. So I’ve kept that one on.
It was a $400+ barrel with easily $500 of work done to it. It’s almost turn-key for your rifle. I do recognize that it’s a bit of a niche product as it sits.
I think asking $250 to get it to sell is reasonable.
Payment via many different means. Contact via PM. More pics upon request.
Sent from my iPhone using Tapatalk
