WTS Bowtech core SR

rgref522

WKR
Joined
Jan 13, 2018
Messages
860
Bowtech core sr 70 lbs flat dark earth.

This bow is not very old and doesn't have much use but fairly described as used. Was planning to give bowtech an honest try over winter and summer leagues. Pinched a nerve in my back and won't be shooting much this winter now. Will be posting a few other bows depending how fast I get back on my feet. A sharp spot developed where the grip is designed to naturally pivot, the grip tape covered that up and fixed and replaced any issues. Very smooth feel.

Bare bow with raptor peep

775 shipped bare

Will load some pics when i get better service


Only trade would be for rx8 ultra in origin camo or wilderness with realtree limbs plus cash from me as i know i want to get my hands back on one of those long term.

Sent from my SM-S921U using Tapatalk
 
Last edited:
OP
R

rgref522

WKR
Joined
Jan 13, 2018
Messages
860
Pics
8279ec9fcde0981dec80b0deb27b41fa.jpg
cb621c0a14dbe1494e99da63000901aa.jpg
2d5c38bf6349ff9f4e9beb9337dfe6c4.jpg
d3179adb2110f9e87219797a52d08cd3.jpg
c5546a2b8d5ed88c502582247952f07c.jpg
4f7574b50dfd3a21b4b49352306161e1.jpg
3e22c96563ce2ac3a5d27b3d105a56c5.jpg


Sent from my SM-S921U using Tapatalk
 

krisn416

WKR
Joined
May 11, 2017
Messages
1,016
Free tip for whoever buys this bow. Swap the annoying part of the grip out. These Grip Lock grips can be easily removed if you want to make the process slightly easier. Note, there is a set screw that acts as a roll-pin under the upper portion of the grip. You can then separate it into two pieces, remove the outermost portion which has that annoying rubber piece that peels off and develops hot spots, and swap with a factory Clutch or Gillingham grip (haven’t tried a Gillingham but should work just the same). Fits like a glove. Reassemble on the bow and you still get about 1/3-1/2 the original Grip Lock range of motion to adjust the grip angle. Way better IMO than the way it comes from the factory.
 
Top