7mm Rem Mag load info

[Jstcynske]

I have H4831sc and Accubond 168 lr's i'm looking to load. Nossler shows 65gr max load with the H4831sc. Anyone have experience with this setup, what have you found works well? My overall length will likely end up somewhere between 3.350 to 3.400.

 

[brad407210]

I pressure out lower than that, but Hornady brass was all I could get so I have trouble hitting max loads

 

[CC11]

Whats the coal in the nosler specs? If you're going to be right around it then I'd start at their recommended starting point and work up. If you're a bit longer then personally I'd start a couple grains above their recommended starting