The buyer backed out so back up.
Bought and sold for years here with no issues. PPff, Zelle or check I wait till it clears.
This is a 700 faux TI. The action was barreled by weaver rifles in Colorado Springs, a good smith, I traded into it used but called verified the build with Weaver. They blue printed receiver and barreled it, and recut the chamber, they also did the cerakote.
Older 700 receiver, pre 84 as it has receiver sight screws, these were better quality back then.
30-06 take off mountain rifle barrel. 22 inches. Factory Caliber and markings still visible, just at about 10 o’clock vs 9.
No silly J lock of course.
Gen 1 TI stock with factory decelerator pad. I have camoed it in krylon fusion that was properly applied and cured, with two coats of matte acrylic over it. Looks good and is tough.
Stock is pillar bedded and lug and tang are bedded.
Guns with trigger tech trigger.
Finished in stainless cerakote, also done by weaver.
Condition is super, only mark on it is one little rough spot under the cerakote on the barrel right under the Remington. Super hard to see and maybe 1/2 long by 1/4.
Gun weighs 6.02 lbs with just the Talley low 30mm rings.
The gun is well bit, the action is smooth and locks up tight.
It liked some 165 federal fusions and tbbcs I shot the best, also tried some 180 hornady and 175 federals. Typical really light barrel gun. First two almost touching. 3rd shot opens it up. Average 3 shot group right at 1 moa, smallest about .75 and largest about 1.5
1050 shipped with talleys.
Send me your cell or email for more pics.
Scope is not for sale right now. Spence
Bought and sold for years here with no issues. PPff, Zelle or check I wait till it clears.
This is a 700 faux TI. The action was barreled by weaver rifles in Colorado Springs, a good smith, I traded into it used but called verified the build with Weaver. They blue printed receiver and barreled it, and recut the chamber, they also did the cerakote.
Older 700 receiver, pre 84 as it has receiver sight screws, these were better quality back then.
30-06 take off mountain rifle barrel. 22 inches. Factory Caliber and markings still visible, just at about 10 o’clock vs 9.
No silly J lock of course.
Gen 1 TI stock with factory decelerator pad. I have camoed it in krylon fusion that was properly applied and cured, with two coats of matte acrylic over it. Looks good and is tough.
Stock is pillar bedded and lug and tang are bedded.
Guns with trigger tech trigger.
Finished in stainless cerakote, also done by weaver.
Condition is super, only mark on it is one little rough spot under the cerakote on the barrel right under the Remington. Super hard to see and maybe 1/2 long by 1/4.
Gun weighs 6.02 lbs with just the Talley low 30mm rings.
The gun is well bit, the action is smooth and locks up tight.
It liked some 165 federal fusions and tbbcs I shot the best, also tried some 180 hornady and 175 federals. Typical really light barrel gun. First two almost touching. 3rd shot opens it up. Average 3 shot group right at 1 moa, smallest about .75 and largest about 1.5
1050 shipped with talleys.
Send me your cell or email for more pics.
Scope is not for sale right now. Spence
