As an update, I figured out why the bow was shooting faster. For some reason the bow shop tightened the limb bolts from where I had them set to 65lbs.
Out of frustration I bit the bullet and purchased by own press and draw board. After 2 turns in yoke tuning and bumping rest down slightly here...
Just got my ez green press and AD draw board, using it for the first time. When I go to crank, the bow wants to tilt with the top cam in board. I have tried playing with the height adjustment of the post with no luck.
I am playing around with the strap as well as it wants to hit my HDX rear...
I think that makes the most sense. I don’t have a gauge currently but I will check the draw. No adjustments were made, I just flipped the fixture over to use more paper. Should have mentioned that.
Good catch. I dialed to mention that I flipped the target at some point, so all shots are consistently left tear.
I’ve since shot a bare shaft through it and the tear is identical, minus the bands obviously. So at this point I think it has to be either cam lean or rest alignment.
Seeking some input on tuning on a Bowtech Reign. The bow has been shooting great for years. Recently had the string replaced, with a different brand than usual. The bow shop paper shot it and only thing that was changed was the string.
Since I’ve had it back, it was shooting left and elevation...
You probably won’t notice a difference within 40. All my hunting arrows are within 1gn. I’m dialed in with just standard nocks and when I put on the light knock that’s about 20gn I can’t tell a difference. This is considering the bow is paper tuned perfectly.