Search results

  1. Q

    Henderson Trimmer - Order of operations

    I size first, but then use a mandrel to set the neck tension to 0.002 or 0.003 depending on the cartridge. I also apply dry lube to the inside of the necks. Fit is snug, but not enough to induce runout or heat.
  2. Q

    6.5 prc with US869

    I don’t think Berger has any load data for 6.5 PRC, but the Hogdon website does for US 869 and various 140 to 153 grain bullets. I am getting a 6.5 PRC this summer, and I planned to try some IMR 8133 I have laying around. I am curious how the 869 works for you, so please post an update when...
  3. Q

    Sierra Gamekings

    I think they started making their own loaded ammunition, which appears to have strained their manufacturing. That and they seem to be focused on 22 and 6.5 offerings for the foreseeable future. I used to shoot their 180 and 200 gr GKs in my 300 Wins, but these were hard to get even before the...
  4. Q

    Powder????

    Same here. IMR 4451 is a good substitute (not exact) for H4350 and Shooters World Precision Rifle is almost an exact match for Varget (SW actually recommends following Varget load data).
  5. Q

    Calculating CBTO

    Accuracy One makes a seating depth comparator that measures from the bullet ogive to the shoulder vs the base of the case. It’s faster than using the caliper type comparators, and you don’t have to worry about the modified case being a different length than your fired/sized brass. Obviously...
  6. Q

    Zero Press and Coax Press

    Both will produce accurate and very consistent reloads. You won’t gain much if anything in precision. The Zero is more comfortable to use, and the turret is nice from a convenience and organization standpoint if you size brass in multiple steps or load for multiple calibers. The universal...
  7. Q

    Unable to develop load for rifle

    I had similar issues with Berger 210s and 215s (also tried 212 ELDX) and H1000, and nearly burned up a barrel trying different combinations of powders charges, primers, seating depth, and neck tension. Finally switched to H4831 SC, and the gun is now a tack driver…with slightly less velocity...
  8. Q

    Hornady auto charge pro or beam scale

    You could use a balance beam scale for rifle load development, and then switch to an electronic scale for volume loading later. Usually you will find that a good powder charge node is about 0.3 grains wide..sometimes wider. You can then just use the mid-point in your electronic scale and not...
  9. Q

    Dies

    Most use FL sizing for hunting and PRS, but I can’t speak to other applications. It’s important to note, however, that even when you FL size, you should only be bumping the shoulders back about 0.002. Pushing the shoulders back to SAAMI specs will overwork the brass, particularly on belted...
  10. Q

    H4831sc

    Powder Valley had a few jugs pop up yesterday, managed to snag one. Missed out on some H1000 1 pounders...had them in my cart but no go.
  11. Q

    Primer question

    I think the general rule is to use magnum primers for any load greater than 65 grains. I am running low on magnum primers myself, so if I can’t buy anything before fall I will be trying LRs.
  12. Q

    Comfiest packs, and why?

    I have a similar build. 6’4” / 215 / 36 inseam and an average length torso. Ended up with a MR Beartooth, after trying Kifaru and EXO. All three are great packs, but the MR felt the most comfortable to me. Unfortunately packs are nearly as personal as boots.
  13. Q

    Worst Rifles

    My first deer rifle...a Remington Woodsmaster 742 semi-auto. Only liked light bullets, and by like I mean put 3 rounds in a 5 inch circle at 100 yards. It typically jammed after the second round and the trigger pull was at least 8 lbs. Lot of great memories with that gun though, and a lot...
  14. Q

    Sleeping Bag for Larger Person

    I am 6’ 4” 230 lbs. I have a Western Mountaineering Sequoia. It’s a cross between a mummy and a rectangular bag, so lots of room. I believe it is rated at 5 degrees, and weighs just over 3 lbs. Definitely not a warm weather sleeping bag, if you want something for summer.
  15. Q

    Western Mountaineering bags, looking for a good 0* bag and would like some user feedback

    I have the WM Sequoia MF, which is rated down to 5 degrees. My coldest night in it was 15, with just base layers on. WM bag ratings are conservative. I would say their ratings are based upon comfort level, where some others seem to be based on a survivability temperature. Keep in mind that...
  16. Q

    kuiu pants and inseams...

    The Kuiu attack pants in tall sizes have a 37” inseam...might work for you. Not sure if they can be let out more.
  17. Q

    kuiu pants and inseams...

    I agree completely, but I have the exact opposite issue. I wear 36 / 36, and need to have everything let out to the max possible. More options would be helpful.
  18. Q

    Ultra light skeleton hunting knife Recommendations?

    I just ordered the Argali. Good carbon steel and more of a handle than some of the others.
  19. Q

    Need help with tent and sleeping bag

    You can probably get by with a tarp or a bivy sack instead of tent. Quilts are also great for warmer weather, plus lighter. If you are back-packing in, don’t skimp on the back pack.
  20. Q

    Need help with tent and sleeping bag

    What is your price range? What temps are you expecting? If you want top of the line sleeping bags or quilts, Western Mountaineering and Feathered Friends are good options. Hilleberg and Seek Outside make great tents and shelters. You options are only limited by your wallet and how much you...

Latest posts

Featured Video

Stats

Threads
347,161
Messages
3,654,440
Members
79,479
Latest member
Woodsborrow77

Latest Articles

Top